rjr513 Posted November 25, 2020 Report Share Posted November 25, 2020 Greetings, Anyone know who's fabricating theses ? Quote Link to comment Share on other sites More sharing options...
frankmarsi Posted November 25, 2020 Report Share Posted November 25, 2020 Locate the exact measurements or make the measurements yourself then, locate a friend who has a good 3d printing set-up. Quote Link to comment Share on other sites More sharing options...
Aadams Posted November 25, 2020 Report Share Posted November 25, 2020 2 hours ago, rjr513 said: Anyone know who's fabricating theses ? I think @Chris1this1 made those. Quote Link to comment Share on other sites More sharing options...
rjr513 Posted November 26, 2020 Author Report Share Posted November 26, 2020 Thanks @Aadams yes, Chris1this1 was the person to make these,however he's informed me that he no longer has access to the 3d printer to do these. Quote Link to comment Share on other sites More sharing options...
cd0nc Posted November 27, 2020 Report Share Posted November 27, 2020 If you ask him for the STL file then you could use an online 3d printing service. I'd happily print them for you but I'm in the UK. Quote Link to comment Share on other sites More sharing options...
Pete B Posted November 27, 2020 Report Share Posted November 27, 2020 I'm aware t hat the original material cracked, but how do you get the tweeter guts out to glue into the new piece? Solvent? Heat? Crack it off? Anyone have the .stl file? Quote Link to comment Share on other sites More sharing options...
Pete B Posted September 22, 2021 Report Share Posted September 22, 2021 Bump, has anyone removed a tweeter for transplant? Also, does anyone know if there were any changes to the shape from the early AR3a to the last version? Pete Quote Link to comment Share on other sites More sharing options...
RoyC Posted September 25, 2021 Report Share Posted September 25, 2021 On 9/22/2021 at 1:03 PM, Pete B said: Bump, has anyone removed a tweeter for transplant? Also, does anyone know if there were any changes to the shape from the early AR3a to the last version? Pete The shape did not change, though the later back-wired version has a thicker flange, and small bumps on the side to accommodate the rear terminals. The magnet is epoxied into the plastic cup making it very difficult to remove, but there is really no need to remove the magnet body. I have been using a 3d printed ring to support the typically warped and broken flange of the early version. Roy Quote Link to comment Share on other sites More sharing options...
Pete B Posted September 25, 2021 Report Share Posted September 25, 2021 Ah okay, thanks Roy good to see you on here, all the best! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.