Jump to content

AR-303 Frequency Response Overlay with AR-3a


Pete B

Recommended Posts

I saw this chart on the forum but can't seem to find it now.

Anyone remember which thread this is in?

Link to comment
Share on other sites

Thanks, that's it!

Do you happen to know if the mid and tweeter pots were all the way up?

Link to comment
Share on other sites

On 5/30/2018 at 10:26 AM, Pete B said:

Thanks, that's it!

Do you happen to know if the mid and tweeter pots were all the way up?

Both controls at or near maximum.  These were my AR-3as that were tested at AR by Bill Bush and KK before being sent to Julian Hirsch for the initial test of the AR-303 by Hirsch-Houck Labs.

 

AR-303-Review_H-H_Julian-Hirsch_June1995.pdf

--Tom

Link to comment
Share on other sites

Thanks Tom,  assuming that the mid was all the way up, then using 1 KHz as a reference 

dropping it about 7 dB would bring it very close to the AR-303.  Also, interesting to note that

My preference listening to the AR-11 was -6 dB on the mid which agrees with that curve 

and whatever the designers did on the 303.  Assuming the AR-11 is very close to the 3a of

course.  

Link to comment
Share on other sites

Does anyone have  AR-3a Technical Data Sheet #L-1621 that they can post?

I had it probably 10 years ago on a computer that hasn't been booted in 5 - 10 years.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...