genek Posted November 9, 2016 Report Share Posted November 9, 2016 If so, could you please measure height x width of the plate that holds the mid and hi driver for me? Thanks. Link to comment Share on other sites More sharing options...
ra.ra Posted November 10, 2016 Report Share Posted November 10, 2016 Are you referring to the 'dual' driver from the AR-48B? If so, it is the same as the mid-tweet combo found in the AR-38B and 58B, but I am unable to find the drawing in the library. Link to comment Share on other sites More sharing options...
genek Posted November 10, 2016 Author Report Share Posted November 10, 2016 Yes, that's the one. I didn't find anything in the drawings either. Link to comment Share on other sites More sharing options...
DavidDru Posted November 10, 2016 Report Share Posted November 10, 2016 In my storage unit and will check next time I go there. I have new surrounds sitting here for the mid driver and woofers to put on. Link to comment Share on other sites More sharing options...
genek Posted November 10, 2016 Author Report Share Posted November 10, 2016 Thanks! Link to comment Share on other sites More sharing options...
ra.ra Posted November 10, 2016 Report Share Posted November 10, 2016 Looks like there are minor variations in the face plate profile - - - this is from an AR-48BX. Link to comment Share on other sites More sharing options...
ra.ra Posted November 10, 2016 Report Share Posted November 10, 2016 Can't vouch for the accuracy of these dimensions, but it looks about right to me. Link to comment Share on other sites More sharing options...
genek Posted November 10, 2016 Author Report Share Posted November 10, 2016 Thanks. The project I have in mind as a width limit of 5.5" but if I can trim .25" off each side it might work. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.