owlsplace Posted July 11, 2018 Author Report Share Posted July 11, 2018 2 hours ago, RoyC said: "but it turned out one of my solder connections from the mid pot to coil failed as in cold. Hard to believe I did that. This is a common issue due to failure to remove, or insufficient removal, of the coil wire's enamel coating prior to soldering. Roy I had the enamel off okay. I must have soldered it with a pencil iron and didn't get the joint hot enough. One of the speakers was wheezing a bit when I played them. I noticed the surround was not attached entirely. There isn't much material there either as in maybe too small. I reattached with E6000 adhesive. These were labeled "Precision Audio" on masking tape around the magnet. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.