Stimpy Posted October 26, 2017 Report Share Posted October 26, 2017 2 hours ago, JKent said: Thanks David. RoyC contacted me and he may have a trim ring to spare! I'll let you know. Stimpy may be in luck. -Kent Thanks Kent! 1 hour ago, DavidR said: OK I have two extra sheets that I never used so I can cut 2 more. The measurements are: 12 and three eights inches OD X 10" ID. I used the trim ring and traced the pattern. So if you both need some that can happen. Thanks David! I'm PM my address, and let me know what I'll owe you??? 58 minutes ago, RoyC said: I found two of 'em, Kent. I'll put one in the mail tomorrow. Roy Thanks Roy. And what a great community! Everyone wins! Link to comment Share on other sites More sharing options...
DavidR Posted October 27, 2017 Report Share Posted October 27, 2017 Stewart, Its a RAOK (Random Act Of Kindness) All I need is your addy info. Link to comment Share on other sites More sharing options...
Stimpy Posted October 27, 2017 Report Share Posted October 27, 2017 4 minutes ago, DavidR said: Stewart, Its a RAOK (Random Act Of Kindness) All I need is your addy info. Thanks! And as if I need to explain (since it's blatantly obvious) ; I don't do acronym's well...! PM'd the address too. Link to comment Share on other sites More sharing options...
Stimpy Posted October 27, 2017 Report Share Posted October 27, 2017 I knew I'd seen the trim rings on eBay. Woofer Trim Rings Link to comment Share on other sites More sharing options...
JKent Posted October 27, 2017 Report Share Posted October 27, 2017 Thanks Stimpy. I saw those too but then noticed they are not truncated on the sides and have only 4 screw holes. Probably 10" or 8". No worries--Roy to the rescue! -Kent Link to comment Share on other sites More sharing options...
JKent Posted December 23, 2017 Report Share Posted December 23, 2017 AR-91s are finished and for sale. Please see the "For Sale" section. Thanks to all. http://www.classicspeakerpages.net/IP.Board/index.php?/topic/9882-fs-ar-91s-in-nj/ Kent Link to comment Share on other sites More sharing options...
Pete B Posted December 29, 2017 Report Share Posted December 29, 2017 Nice work and to see them finished and that you didn't part them out! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.