Aadams Posted July 23, 2020 Report Share Posted July 23, 2020 If you connect them to your a and b speaker terminals they will show around 2.5 ohms to your receiver. Your receiver will interrupt, maybe permanently. You could perhaps connect in series but you probably would be safer using an amp rated for 2 ohm loads. See what others say. Adams Quote Link to comment Share on other sites More sharing options...
ar_pro Posted July 23, 2020 Report Share Posted July 23, 2020 Are you asking if you can use an AR-1 on one channel of a Sony receiver, and an AR-2 on the other channel? The short answer would be "yes", but the combination wouldn't be ideal for a few reasons. An AR-1 in working, unmodified original condition is worth a little bit of money; the Altec 755A driver alone is selling for close to $2,000, so you might want to investigate this before doing anything to the speaker. Quote Link to comment Share on other sites More sharing options...
rl1856 Posted October 16, 2020 Report Share Posted October 16, 2020 On 7/23/2020 at 4:57 PM, ar_pro said: Are you asking if you can use an AR-1 on one channel of a Sony receiver, and an AR-2 on the other channel? The short answer would be "yes", but the combination wouldn't be ideal for a few reasons. An AR-1 in working, unmodified original condition is worth a little bit of money; the Altec 755A driver alone is selling for close to $2,000, so you might want to investigate this before doing anything to the speaker. Was a "1W"....woofer only. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.