Guest matty g Posted January 17, 2007 Report Share Posted January 17, 2007 Hi All On one of the threads about the tweeter and mid controls someone (maybe Carl?) was explaining how to properly wire a resistor network to control the output of the high and mid drivers. As I recall, the method was to wire a resistor of the same value as the driver in parallel with that driver, then a resistor of the value needed to attenuate that driver in series with..... the driver? That's where I go blank. Was the attenuating resistor before or after the parallel resistor? I've searched all over, but I can't find that thread. If the author reads this can you please re-post it? I'm in the middle of a project that I don't want to close up until I'm sure of the facts!ThanksMatt Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.